Details how to mount a transistor to a heatsink, in this case a 2N3055 transistor, though it applies to any TO-3 semiconductor package that can heat up durin...
- Brian D
Single 2N3055 flyback driver with base emitter and collector emitter junctions protected from kickback with UF4007 fast diodes. This unit can run long with m...
It's easy to cut open a power transistor like the 2N3055 to expose the NPN silicon material inside to make a solar cell. When exposed to sunlight, or househo...
Pequena análise do transistor 2N3055 vendido no mercado brasileiro.
Genuine Toshiba 2n3055 as 250uW solar cell. The emitter is heavily doped (eg, phosphorus ions), so contains a lot of valence electrons. These electrons are i...
Dimly it flashes, less than 1.2 v input . Same circuit as before but with NE-2 removed and CFL wired in place. 13 watt 120 v unmodified CFL.
I made a solar panel out of solar cells made from 2N3055 power transistors. It produces around 1.5 volts and 4 milliamps, depending on the amount of sunlight...
Ein 2N3055 Transistor wurde aufgeschnitten und die beiden Dioden in Durchlass- und Sperrrichtung mit einer Konstantstromquelle betrieben. Das dabei entstehen...
The Darlington made with a BD 139 and a 2N3055 is ideal, because the BD 139 has a maximum base voltage from 80 V. So handled with a little bit care, this Dar...
- Bobby CrazyWolf
I made this using an Arduino for the PWM signal to the 2n3055 transistors to control the speed of a wheelchair motor. I took the breaks out of the motor to r...
Page: 1 of 944